Bench Top Compression Molding Presses for Laboratory Applications from Carver
The Manual ASTM Model 12-12H-ASTM (catalog# 4391) was designed to perform the ASTM compression molding of test plaques or bar specimens of Type I, II, III, IV or V polyethylene and other thermoplastic resins. The procedure is in conformance with ASTM Method D 4703 Procedure C (formerly D1928, Procedure C). This compression molding press is equipped with heating and manually water cooled platens and a programmable digital controller which has a heating/cooling loop for each platen and built-in program for the required 15°/minute ±2°C cooling rate.Get more news about compression moulding machine,you can vist our website!
Clamping force 12 tons
Adjustable Daylight 0" – 10" (Factory set at 4-½”)
Stroke 5-1/8”
Four (4) fully threaded columns
Two (2) 12” x 12” electrically heated steel platens cored for ASTM water cooling, Temperature range up to 343ºC, sized for 8 ºC/minute temperature rise, Platen & perimeter insulation, Programmed platen cooling per ASTM D-4703 Procedure C (formerly D1928 procedure C), Package includes platens designed for flood cooling, inlet and outlet manifolds and valves for platens, programmable temperature controllers with ramp capability, One digital temperature controller per platen
0-24,000 lb analog pressure gauge (in 200 lb increments)
230V 1-Ph supply voltage
Electrical disconnect (non-fused)
Dimensions: 32 ”L-R x 29”F-B x 53”H (uncrated)
Weight: 770 pounds (uncrated)
The following calibrations and certifications are provided with the press: Pressure calibration and certification traceable to NIST (10 point check), Calibration of platen temperature controls (10 point check), Temperature uniformity of platens, and Platen parallelism.
The Manual ASTM Model 12-12H-ASTM (catalog# 4391) was designed to perform the ASTM compression molding of test plaques or bar specimens of Type I, II, III, IV or V polyethylene and other thermoplastic resins. The procedure is in conformance with ASTM Method D 4703 Procedure C (formerly D1928, Procedure C). This compression molding press is equipped with heating and manually water cooled platens and a programmable digital controller which has a heating/cooling loop for each platen and built-in program for the required 15°/minute ±2°C cooling rate.Get more news about compression moulding machine,you can vist our website!
Clamping force 12 tons
Adjustable Daylight 0" – 10" (Factory set at 4-½”)
Stroke 5-1/8”
Four (4) fully threaded columns
Two (2) 12” x 12” electrically heated steel platens cored for ASTM water cooling, Temperature range up to 343ºC, sized for 8 ºC/minute temperature rise, Platen & perimeter insulation, Programmed platen cooling per ASTM D-4703 Procedure C (formerly D1928 procedure C), Package includes platens designed for flood cooling, inlet and outlet manifolds and valves for platens, programmable temperature controllers with ramp capability, One digital temperature controller per platen
0-24,000 lb analog pressure gauge (in 200 lb increments)
230V 1-Ph supply voltage
Electrical disconnect (non-fused)
Dimensions: 32 ”L-R x 29”F-B x 53”H (uncrated)
Weight: 770 pounds (uncrated)
The following calibrations and certifications are provided with the press: Pressure calibration and certification traceable to NIST (10 point check), Calibration of platen temperature controls (10 point check), Temperature uniformity of platens, and Platen parallelism.