Character Art Exchange

Analysis of Lubrication System of Cone Construction Waste Crusher


In the production process of the cone-shaped construction waste crusher, in order to reduce the impact of the wear on the parts when the parts are used, it is necessary to lubricate different parts inside the equipment. This lubrication process mainly reduces the degree of wear. To ensure the smooth operation of the equipment, and later for the better realization of lubrication, the automatic lubrication device - lubrication system is adopted, so that the lubrication operation can be realized quantitatively and quantitatively, and the protection of the internal parts of the cone construction waste crusher can be better. At the same time, good lubrication operation can reduce the occurrence of faults in production and ensure the efficiency of production. Here is to introduce the lubrication system of the machine.
In the interior of the cone construction waste crusher, the lubrication system mainly uses the oil pump to press the lubricating oil. The oil enters the lower gap of the eccentric bushing from the oil hole on the lower cover of the frame through the oil pipeline, and then is divided into two paths, respectively. For the lubrication operation of different parts of the equipment, the clearance between the main shaft and the eccentric bushing rises until the oil retaining ring is blocked and overflows to the bevel gear, and the other path rises along the gap between the eccentric bushing and the bushing, and the thrust ring Also enter the bevel gear, so that the bevel gear lubricant is discharged through the drain pipe. The suspension device of the construction waste crusher is softened by dry oil, and the oil is pressed into the dry oil by hand pressure. In this process, the three collars of the lower part of the equipment must be sealed to prevent dust from entering.
Through the analysis of the internal lubrication system of the cone construction waste crusher and the realization of the lubrication process, it can be found that in the interior of the equipment, the lubrication system realizes the lubrication of most parts, and the lubrication process can be autonomous. Realization, no need for manual operation, just need to refuel regularly.
In addition, in the process of using the construction waste crusher, in order to better realize the lubrication effect, it is necessary to periodically clean the system to prevent dust from entering, to prevent the lubrication failure caused by the pollution phenomenon, and then to lubricate. The choice of oil should also be cautious, the right type of lubricant can double the lubrication effect.
The article mainly introduces the analysis of the lubrication system of the cone-shaped construction waste crusher. It is mainly about the introduction of the lubrication system, the lubrication process, and the analysis of the problems that should be paid attention to when lubricating. Good lubrication is to achieve good machine waste for construction. Important conditions for the process.

You must be logged in to comment.

Register
Log in
Username

Password:

forgot your password?

or OpenID:
or Log in with Google