It is also very normal for the sand making machine to encounter problems during work, just like people are sick, as long as the right medicine can solve this problem. Today we are going to discuss how to solve the problem of the sharp swing of the sand making machine during work, then there are three possible reasons:
The sand making machine may also have obstructions in the impeller flow passage. If there is obstruction in the impeller flow passage, the feeding will be uneven, and the body swings too much. As long as the obstruction on the impeller flow passage is taken out, the body can be swung too large. The problem.
It may be that the equipment is too large due to the excessive particle size of the feed. When the sand making machine is designed, the feed size of the equipment is generally 4 to 5 cm. Generally, the equipment feed size is 3 to 4 cm. The amount can be increased. If the feeding is too large, the equipment will swing too much. If the feeding is too small, the collision is not enough and it is difficult to reach the finished sand amount.
It may be that the wearing parts on the impeller of the sand making machine are worn more seriously. If the wearing parts of the impeller are seriously worn, the internal operation of the sand making machine will be unstable, causing the swing to be too large. At this time, as long as the wearing parts are replaced, the internal impeller of the sand making machine can be balanced.
It is also very normal for the sand making machine to encounter problems during work, just like people are sick, as long as the right medicine can solve this problem. Today we are going to discuss how to solve the problem of the sharp swing of the sand making machine during work, then there are three possible reasons:
The sand making machine may also have obstructions in the impeller flow passage. If there is obstruction in the impeller flow passage, the feeding will be uneven, and the body swings too much. As long as the obstruction on the impeller flow passage is taken out, the body can be swung too large. The problem.
It may be that the equipment is too large due to the excessive particle size of the feed. When the sand making machine is designed, the feed size of the equipment is generally 4 to 5 cm. Generally, the equipment feed size is 3 to 4 cm. The amount can be increased. If the feeding is too large, the equipment will swing too much. If the feeding is too small, the collision is not enough and it is difficult to reach the finished sand amount.
It may be that the wearing parts on the impeller of the sand making machine are worn more seriously. If the wearing parts of the impeller are seriously worn, the internal operation of the sand making machine will be unstable, causing the swing to be too large. At this time, as long as the wearing parts are replaced, the internal impeller of the sand making machine can be balanced.