In the process of turning the barrel of the Ball Mill, the grinding body also has a sliding phenomenon, and the material is grounded during the sliding process. In order to effectively utilize the grinding effect, when the general grain size of the material is large, the grinding body is fine. The body partition plate is divided into two sections, that is, it becomes a double warehouse. When the material enters the first warehouse, it is crushed by the steel ball. When the material enters the second warehouse, the steel section grinds the material, and the finely qualified material is discharged from the discharge end. The hollow shaft is discharged, and when the material with small feed particles is ground, such as sand slag slag, coarse fly ash, the mill cylinder can be free of baffles, and it can be a single-cylinder barrel mill, and the grinding body can also use steel segments. .
The raw material is ground into a hollow cylinder through a hollow journal, and the cylinder is filled with grinding media of various diameters (steel balls, steel bars or gravels, etc.). When the cylinder rotates around the horizontal axis at a certain rotation speed, the medium and the raw materials contained in the cylinder are separated from the cylinder by the centrifugal force and the friction force, and when the gravity reaches the certain height, when the gravity is greater than the centrifugal force. The body wall is thrown down or rolled down, crushing the ore due to impact. At the same time, during the rotation of the Grinding Mill, the sliding movement of the grinding media to each other also produces a grinding effect on the raw materials. The ground material is discharged through a hollow journal.
In the process of turning the barrel of the Ball Mill, the grinding body also has a sliding phenomenon, and the material is grounded during the sliding process. In order to effectively utilize the grinding effect, when the general grain size of the material is large, the grinding body is fine. The body partition plate is divided into two sections, that is, it becomes a double warehouse. When the material enters the first warehouse, it is crushed by the steel ball. When the material enters the second warehouse, the steel section grinds the material, and the finely qualified material is discharged from the discharge end. The hollow shaft is discharged, and when the material with small feed particles is ground, such as sand slag slag, coarse fly ash, the mill cylinder can be free of baffles, and it can be a single-cylinder barrel mill, and the grinding body can also use steel segments. .
The raw material is ground into a hollow cylinder through a hollow journal, and the cylinder is filled with grinding media of various diameters (steel balls, steel bars or gravels, etc.). When the cylinder rotates around the horizontal axis at a certain rotation speed, the medium and the raw materials contained in the cylinder are separated from the cylinder by the centrifugal force and the friction force, and when the gravity reaches the certain height, when the gravity is greater than the centrifugal force. The body wall is thrown down or rolled down, crushing the ore due to impact. At the same time, during the rotation of the Grinding Mill, the sliding movement of the grinding media to each other also produces a grinding effect on the raw materials. The ground material is discharged through a hollow journal.