The V-belt of the Portable Crusher Plant to the roller should not be operated in an environment higher than 60 °C. If the wheel hole of the pulley has cracks, the wheel groove notch or the groove surface should be replaced in time, the belt should be seriously worn and the belt and the groove bottom contact, the belt is aging, and there are cracks or plastic distortions. It is replaced accordingly and the belts on the same pulley should be replaced at the same time.
In order to prevent the slippery phenomenon of the mobile crusher belt, it should be applied to the working surface of the belt with belt wax or belt oil, but it is generally not used. If the belt slip occurs, the tension of the belt can be increased. Keep the belt and pulley clean and tidy to prevent dust from entering.
V-belts from different factories or different degrees of old and new can not be used in the same group, and belts of different specifications cannot replace each other. The belt should be protected from direct contact with acids, alkalis, diesel, oil, gasoline, etc., and should be protected from direct sunlight. The belt of the mobile crusher cannot be too tight or too loose during operation, so the belt should be adjusted at any time.
The V-belt of the Portable Crusher Plant to the roller should not be operated in an environment higher than 60 °C. If the wheel hole of the pulley has cracks, the wheel groove notch or the groove surface should be replaced in time, the belt should be seriously worn and the belt and the groove bottom contact, the belt is aging, and there are cracks or plastic distortions. It is replaced accordingly and the belts on the same pulley should be replaced at the same time.
In order to prevent the slippery phenomenon of the mobile crusher belt, it should be applied to the working surface of the belt with belt wax or belt oil, but it is generally not used. If the belt slip occurs, the tension of the belt can be increased. Keep the belt and pulley clean and tidy to prevent dust from entering.
V-belts from different factories or different degrees of old and new can not be used in the same group, and belts of different specifications cannot replace each other. The belt should be protected from direct contact with acids, alkalis, diesel, oil, gasoline, etc., and should be protected from direct sunlight. The belt of the mobile crusher cannot be too tight or too loose during operation, so the belt should be adjusted at any time.